Using Spell Interrupt Rate Down

Talk about AshitaCast here. Need help with setting things up? Questions about how to do something? Post here.
Post Reply
pantafernando
Posts: 13
Joined: Mon Nov 06, 2017 6:12 am

Using Spell Interrupt Rate Down

Post by pantafernando » Tue Dec 26, 2017 4:29 am

Hi.

I play as a RUN and one thing that made me look for Ashitacast (im used to native swap options) is the need of using SID gear during the casting. Its almost impossible to do with native options so Im looking for some help how can I set a xml to make it work. What i need is some advice how can I can write a script to 1) use full fast cast gear in the moment i start casting, 2) change to full SID gear during entire casting duration then 3) change for full enmity gear in the moment the magic is casted.

Any help i would appreciate.

Thanks in advance.
Finbar
Posts: 7
Joined: Tue May 08, 2018 4:04 pm

Re: Using Spell Interrupt Rate Down

Post by Finbar » Mon Sep 03, 2018 5:51 pm

Probably too late for it to matter here, but there's only three states of casting.

Pre: What is looked at before the spell is cast; notably, Fast Cast.
Mid: Needs to be equipped during the spell cast, before and when it completes; this determines what stats are applied to a spell. In effect, despite its name, this ultimately applies (is evaluated) at the end of casting, even though it effectively needs to be equipped in the middle.
Post: What is equipped after the spell is done casting; the idle or TP set.

Spell Interruption Rate gear needs to be equipped during midcast. So does enmity gear. You can't get the effects of both, as midcast gear isn't evaluated until the end of the spell's casting.

Hope this helps.
Post Reply